![]() ![]() ![]() ![]() NOTE: For Futaba’s 12Z, 14MZ, 18MZ, and 4YF on 2.4GHz, refer to the instructions included with the required optional PowerĪdapter TACM0007 for specific setup details.Ģ. Connect the cable’s 3-pin connector to AnyLink’s INPUT jack.ģ. Turn the Tx power switch on. For computer radios having the option to transmit a signal when Tx power is turned ON, make sureĤ. AnyLink should sound one beep and its LED should illuminate.ĥ. Skip to the COMPATIBLE RECEIVERS section on page 5.ġ. Connect the appropriate cable to the Tx trainer jack. NOTE:įor Optic 5, Optic 6 Sport, and Eclipse 7 transmitters on 2.4GHz, refer to the instructions included with the required optional Power Adapter TACM0005 for specific setup details. For Aurora 9 transmitters, refer to the instructions included with the required optional cable TACM0004 for specific setup details. Mounting strips, mount AnyLink high on the rear of the Tx, extending its antenna upwards from the top of the Tx as much as possible as shown at right.Ģ. Remove the Rf module or crystal, or disable the Rf section in the hostģ. Leave the Tx’s own antenna in a retracted or folded position.Ĥ. For computer radios make sure the modulation is set to PPM mode.ĥ. Move the throttle stick to minimum leave all other sticks at center.Ħ. Go to the appropriate section below depending on the brand of transmitter being used.ġ. Carefully connect the appropriate cable to the Tx trainer jack. Operation. Make sure all connections are solid physically and cannot easily become dislodged at any time. AnyLink must be used with a Tx having a throttle stick that does NOT automatically spring back to center. To do so could result in personal injury if the motor turns unexpectedly. Make sure all batteries are fully charged prior to Setting up AnyLink to work with the flight system. Failure ![]() Not listed may or may not be compatible with AnyLink. Checkįor the most updated compatibility chart. This chart is current as of the date of the printing of this manual. Transmitters *Includes a rechargeable 6.6V LiFe battery. LiFe-compatible charger required. Optic 5 (2.4GHz), Optic 6 Sport, Eclipse 7 (2.4GHz)Īll aircraft transmitters with trainer jack Refer to the chart below to determine which cable is required for a Tx to function with AnyLink. See your local hobby retailer to purchase optional cables TACM0003, 0004, 0005, and 0007.ĤYF (72MHz), 4YBF, 6EX, 6J, 7C, 8FG, 9C, 10C, 12FGĤVF, 5U, 6A, 6DA, 6H, 6YF, 6YG, 7NFK, 8U, 9Z Transmitters having a square trainer jack (except Futaba 12Z,ġ4MZ, 18MZ, and 4YF on 2.4GHz). The remaining cable is for JR Included cable with two plugs is for Futaba All compatible transmitters must have a trainer/DSC jack. AnĪdapter cable connects AnyLink to the Tx trainer jack. The ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |